Innotech Device Communications Bedienungsanleitung PDF herunterladen (Seite 31)

Page 23

Chapter 4 – Conguring Ethernet settings of Innotech devices

DS 99.05 – Ethernet Setup Manual for Device Communications

Refer to Figure 4-18 and the table below for detailed information to help you congure 3.

the IG01 to suit your LAN requirements.

Callout Area on the screen Description

Address Type

Always select Static to avoid network communication

problems, or problems communicating with the iComm

software.

IP Address

Enter the static IP address you want to assign the IG01

as per your LAN requirements.

NetMask Enter the subnet mask as per your LAN requirements.

Apply

When you have entered the desired Ethernet settings,

click on Apply to save the new settings.

Congure Ethernet settings of IG01Figure 4-18:

When the new settings have been applied, Status: Done will be displayed at the bottom

left corner of the IG01 web page.

If you are having difculty accessing the IG01 embedded web server at any point, refer to

Chapter 5 – General Troubleshooting for general troubleshooting information.

NOTE

Please note that when the IP address of your device is changed and saved as described here, you may

have to modify your computer network settings to be on the same network range as your device if it is

dierent. You can then access the embedded web server by entering the new IP address assigned to

your device into the browser address bar.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 41 42

Keine Kommentare

Innotech Device Communications Bedienungsanleitung Seite 31