Innotech Genesis V4 System Bedienungsanleitung PDF herunterladen (Seite 40)

Installation Instructions for Innotech Genesis Systems

Edition 011100

3-14

• GENII AIM AISC – Analogue Input Module AISC

• GENII DO5 – D05 Digital AISC

• GENII I05 – 0-5mA Passive AISC

• GENII I20 – 0-20mA Passive AISC

• GENII TH1 – Thermistor, Type 1 AISC

• GENII TH9 – Thermistor, Type 9 AISC

• GENII V05 – 0-5Vdc AISC

• GENII V10 – 0-10Vdc AISC

3-3.3.3. Analogue Outputs. The Genesis I Digital Controller’s analogue input

requirements are the same as for the Genesis II Digital Controller, except that the Genesis I

Controller uses only six analogue output channels. Refer to Table 3-8 for a list of analogue

output terminals.

Table 3-8. Genesis I Digital Controller Analogue Outputs.

TERMINAL SIGNAL TERMINAL SIGNAL

65 AO1 69 Common

66 AO2 70 Common

67 AO3 77 AO5

68 AO4 78 AO6

Note: Terminals 71 through 76 not used.

3-3.3.4. LEM Connector. The LEM connector is a ribbon cable connector that

provides access between the Genesis II Digital Controller and local expansion modules.

Connectors along the cable are spaced at 150mm intervals; therefore it is critical that the

LEMs are located as close as possible to the Digital Controller and to each other.

3-4. WIRING OF EXPANSION MODULES.

The following paragraphs provide wiring information for local expansion module and remote

expansion modules. LEMs and REMs can be used with Genesis I Digital Controllers, Genesis II

Digital Controllers or Genesis II MPCs. Controllers used with REMs must have Version 4

Firmware installed to support the REM. In no case may LEMs and REMs be used with the same

controller

3-4.1. LOCAL EXPANSION MODULES. Genesis I and II Systems use three types

of LEMs:

• GENII AIM Analogue Input Module

• GENII DIM Digital Input Module

• GENII DOM Digital Output Module.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 114 115

Keine Kommentare

Innotech Genesis V4 System Bedienungsanleitung Seite 40