Innotech Maxim Bedienungsanleitung PDF herunterladen (Seite 57)

Page 57

MAXIM Installation Instructions

A-2.4 CT01 Menus and Navigation

The interface of the CT01 is relatively easy to navigate. To access the Menu page press the Exit

button. To select how the CT01 is connected to the controller, select Setup and press the Enter

button. Use the Up and Down navigation buttons to select between Network or Standalone. If the

CT01 is connected directly to a controller as illustrated in Figure A-1 preivously, you will need to select

Standalone. If the CT01 is connected to the network as illustrated in Figure A-2 and Figure A-3, you

will need to select Network.

A-3 Logging onto the Controller

Connect the CT01 to the desired controller, or to the sub system network as described earlier, and the

screen should activate.

Press the Log On button.

Select the controller to communicate with and press the Enter button. If you are connected to a sub

system network, you will have a list of controllers on that network to choose from.

To navigate to the Watch Menu, select Status and press the Enter button. Now select Watches and

press the Enter button. You can now use the Up and Down navigation buttons to scroll through the

available selections. When indicated at the top of the LCD, you can press the Enter button to edit the

applicable set points. Pressing the Exit button will take you back to the previous menu or page. You

can view the following parameters in the Watch Menu:

• Zone temperature and temperature set point

• Cooling and heating demand

• Heater bank request

• Minimum and maximum air flow

• Airflow(L/S), air volume(m/3) and actual airflow set point

• Actuator travel time (only on DODC motors)

• Actuator demand

• Manual VAV calibration (for calibrating the pressure sensor and actuator position)

• Velocity Pressure (Pa)

• Pressure sensor fault status

• Commission mode enable, actuator manual enable, and actuator manual position.

Figure A-4: CT01 Interface - Navigation and Menus

Communication LEDs

Log On Button

Enter Button

Exit Button

Navigation Buttons

1 2 ... 52 53 54 55 56 57 58 59 60

Keine Kommentare

Innotech Maxim Bedienungsanleitung Seite 57