Innotech eServer Bedienungsanleitung PDF herunterladen (Seite 23)

Page 23

eServer Setup and Site Installation Instructions

2-2.4.1 Computer Setup

Once the ADSL connection to the eServer Host computer is completed, the computer must be

protected. The following is required to complete this step:

• Antivirus soware from a reputable provider. Some antivirus and security soware will

block eServer communication and port traic by default. If this occurs, allow the required

communications on the computer. Refer to the specific antivirus or security soware help manual

for more details on how to do this.

• Firewall enabled and configured - either Windows firewall or third party soware. Ensure to

enable the required ports for eServer communications.

• Administration rights on the computer with a valid username and password

• Static IP address for the ADSL connection

• Static IP address on the local computer

2-2.3.2 Router Setup

1. Set up the computer with a temporary IP address and make it the same as the default IP range

of the ADSL router being used.

2. Log onto the router and set a new username and password. Go to the Port Settings (generally

found in Security) and allow the ports described previously in 2-2.2.2 Port Forwarding and

Firewalls.

3. You will need to forward the requests for each Port to the static IP address of the computer

running iComm and/or eServer as shown below in Figure 2-2 (Please note that this screenshot

is for soware that is specific to this router, and may vary depending on the brand and model of

the router).

Figure 2-2: Example of Forwarding Requests for Ports to Static Ip Addresses

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 117 118

Keine Kommentare

Innotech eServer Bedienungsanleitung Seite 23