Innotech eServer Bedienungsanleitung PDF herunterladen (Seite 74)

eServer Setup and Site Installation Instructions

Page 74 © Mass Electronics Pty Ltd 2009Edition 5.0 dated 07/01/2014

Figure 4-1: Open the Magellan project

4-1 Overview

This section provides an overview of the steps required to configure security and access control on

eServer soware to allow remote computers to access Magellan projects via the eServer soware.

Additionally, steps are provided to enable eServer to communicate with an SQL Server database.

4-2 Configure eServer Project Settings

4-2.1 Overview

This section provides instructions on how to configure your eServer Project Settings to work as part

of a system including Innotech eServer 1.20 or greater. Specifically, this section provides information

on how to open your project and set project connection properties for a database, iComm server

and connected devices.

4-2.2 Launch Project for Configuration

Shutdown eServer and open Magellan Builder v1.20 or greater. From the menu bar, open the

Magellan Package, as illustrate below in Figure 4-1.

Ensure you are logged into the computer as a System Administrator. You will need to use Magellan Builder v1.20

or greater to congure the project settings, so ensure you have a Magellan Builder security dongle in addition to the

eServer security dongle. Once you have setup the eServer Host computer, you may remove the Magellan Builder

security dongle, leaving just the eServer security dongle installed.

NOTE

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 117 118

Keine Kommentare

Innotech eServer Bedienungsanleitung Seite 74